Connection Panel; Technical Specifications - HQ-Power PA100U Manual Del Usuario

Refer to illustration 2 on page 2 of this manual.
1 RECORD OUTPUT L/R
Left and right RCA connections for your recording device. The volume level is not influenced by the
master control buttons.
2 SPEAKER 2 OUTPUT
¼" jack connection for the auxiliary speaker.
3 FUSE
Fuse holder with 1A fuse.
4 12 VDC CONNECTION
5 FUSE
Fuse holder with 1A fuse.
6 POWER SUPPLY INPUT
Input for the power supply cord.

6. Technical Specifications

power supply
input sensitivity/impedance
MIC
AUX
output level
amplifier
RECORD
frequency response
S/N ratio (@ 1k Hz)
MIC
LINE
distortion
MIC
LINE
master tone control
treble
bass
delay time
autonomy (fully charged)
dimensions
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. The information in this
manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved.
No part of this manual or may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
12.09.2011
PA100U

CONNECTION PANEL

230 VAC ~ 50 Hz or internal 12 V battery
3.0 mV / 600 Ω
300 mV / 28k Ω
16 W / 4 Ω
775 mV / 10k Ω
20 Hz ~ 20k Hz ± 2 dB
> 80 dB / 3 mV
> 90 dB / 300 mv
0.5%
0.3%
12k Hz ± 15 dB
80 Hz ± 15 dB
50 ms ~ 120 ms
6 h
310 x 255 x 120 mm
5.6 kg
5
Rev. 01
©Velleman nv