Pioneer SGY-PM910H Manual De Usuario página 11

4.
Switch the sensor mode.
By pushing the push switch in the right
transmitter for more than 2 seconds,
the LEDs on the right transmitter blink
green. After confirming the blink,
release the push switch. When the blink
stops, the LEDs on the left and right
transmitters light as follows depending
on the changed sensor mode.
•
Pedaling monitor mode:
The LEDs light green for 10 seconds.
•
Power meter mode:
The LEDs light orange for 10
seconds.
• For use with Pioneer's SGX-CA500,
set the sensor mode to pedaling
monitor mode. For use with other
cyclocomputer brands, set the
sensor mode to power meter mode.
• Please do not push the push switch
for more than 5 seconds. Doing
so changes the mode to calibrate
the magnet position. Refer to the
Installation Manual for details.
• If the pairing between the left and
right transmitters fails, the LEDs
blink red 5 times.
• It may take about 10 seconds to
switch the sensor mode depending
on the radio transmission conditions.
5.
Install the right transmitter
cover and tighten the screws
to fix it in place.
Use a tool that can measure the torque
to tighten the screws.
• Tightening torque: 30 cN·m
• Install the transmitter cover and
screw the screws in firmly to ensure
water resistant performance.
EN
Switching Modes
11