Troubleshooting - Pioneer SGY-PM910H Manual De Usuario

Troubleshooting

EN
Refer to the following suggestions if you have any problems installing or
using the product.
If you cannot find what you want to know here, ask the shop where you bought
the product.
■ I cannot pair with the Cyclocomputer in the power meter mode or pedaling
monitor mode.
Cause
The battery is almost empty.
(+) or (-) side of the battery is
installed in the opposite side.
Pedaling monitor sensor mode is
wrong.
There are other wireless equipment
or microwave ovens near by.
Another sensor is paired with the
Cyclocomputer.
■ I cannot pair with the Cyclocomputer in the power meter mode.
Cause
Pairing between right and left
sensors fails.
16
Solution
If the LEDs do not light for more than 5 seconds after
installing the batteries, remove the batteries once, and after
more than 1 minute, install them again. If the LEDs still do
not light, the battery may be almost empty. Replace the
battery with a new one.
Install the battery in the proper side (see page 7).
Check the mode and pair with the Cyclocomputer again (see
page 10).
Move away from other wireless equipment or microwave
ovens. Move the sensor closer to the Cyclocomputer and
pair them.
Move away from other sensors by more than 10 m or specify
the device number to pair the Cyclocomputer. Refer to the
Installation Manual.
Solution
Check the sensor mode by pushing the push switch. If the
left and right LEDs do not light orange, push and hold the
push switch to switch to power meter mode (see page 10).