Operation; Switching On/Off And Adjusting Temperature; Switching Off Automatically - Silvercrest SHGK 32 A1 Instrucciones De Servicio

Peine alisador de cabello
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 56
__296201_Haar-Glättungskamm_B8.book Seite 16 Montag, 18. Dezember 2017 1:57 13

5. Operation

DANGER! - Fire hazard!
Never cover the device or place it on
soft objects (e.g. towels). As long as the
device is switched on and/or hot, al-
ways place it on a stable, flat, heat-re-
sistant surface.
DANGER! Risk of injury
through burning!
Never touch the hot comb insert with
ceramic coating 1.
NOTE: Before using it for the first time,
switch the device on for a few minutes and
set it to the highest temperature (180 °C). As
a result of the manufacturing process, you
may notice a slight odour. This is normal and
only occurs during first use. Ensure that the
room is well ventilated.
5.1
Switching on/off and
adjusting temperature
1. Place the device on a heat-resistant sur-
face.
2. Connect the mains plug 1 to a properly
installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
3. Press the on/off button
prox. 2 seconds to switch the device
on. The display 2 shows 150.
4. Use the +/– 3 buttons to set the desired
temperature between 100 °C and
180 °C in 10 °C steps. LED segments
moving clockwise in the display 2 will
indicate that the device is heating up.
16 GB
NOTE: LED segments running anticlockwise
indicate that the device is cooling down.
Wait until the desired temperature appears
in the display before straightening your hair.
5. In order to avoid changing the tempera-
ture by accidentally pressing the
+/- 3 buttons, you can lock these but-
tons.
- Press one of the +/- 3 buttons for ap-
prox. 2 seconds. The buttons are now
locked. The display 2 shows
- Press one of the +/- 3 buttons again
for approx. 2 seconds. The buttons
are now unlocked. The display 2
stops showing
6. Press the on/off button
prox. 2 seconds to switch the device
off.
7. Allow the device to cool down on the
heat-resistant surface.

Switching off automatically

If you do not press a button on the switched-
on device for 30 minutes, it will switch off
automatically. Before this happens, the tem-
perature display will flash in the display 2.
Press the on/off button
2 seconds to switch the device back on.
4 for ap-
.
.
4 for ap-
4 for approx.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

296201

Tabla de contenido