Before Straightening; Automatic Switch-Off; Operation; Switching On/Off - Silvercrest SHGP 36 A1 Instrucciones De Uso

Before straightening

■ The hair should be clean, dry and free of styling products . The only excep-
tions to this are special products that promote the straightening of the hair .
■ Comb the hair thoroughly before straightening so that there are no knots in it .

Automatic switch-off

This appliance is fitted with an automatic switch-off system . After 30 minutes the
appliance stops heating automatically . The indicator lamp 4 flashes and you
hear a warning beep every 10 seconds until the ON/OFF switch 3 is pressed .
If you want to continue using the appliance, switch it off for a moment and then
back on again .
NOTE
► The automatic switch-off is a safety function only . It is not intended as a
replacement for switching the appliance off properly by using the ON/
OFF switch 3!

Operation

Switching on/off

NOTE
► The hotplates 5 6 must be free of dirt . Clean them before use if required
(see section "Cleaning") .
1) The appliance is locked with the catch 2 .
Press the hotplates 5 6 together and press the
to unlock the appliance .
Now you can open the hair straightener all the way .
2) Insert the plug into a mains power socket .
3) Push the ON/OFF switch 3 forwards . The indicator lamp 4 starts flashing
red to indicate that the appliance is heating up .
4) As soon as the hair straightener has heated up to approx . 120°C, you hear
three beeps and the indicator lamp 4 lights up permanently red .
NOTE
► During longer use the appliance heats up to around 190°C (+/− 10°C) .
5) When you have finished styling your hair, push the ON/OFF switch 3 to
the rear . You will hear a beep and the indicator lamp 4 goes out .
6) Pull out the plug and allow the appliance to cool down completely .
7) Press the hotplates 5 6 together and press the
to lock the appliance .
SHGP 36 A1
symbol on the catch 2
symbol on the catch 2
GB │ IE 19
│
■