Elay Time; Ause In The Process Of Baking; Emo Function; Hild Lock - EAS ELECTRIC EMV48DTN Manual De Instrucciones

select the desired function,"
-Press " " to set baking time , use "
59 seconds can be set as maximum)
"again to set delay time, the delay time symbol "
-Press"
delay time setting ,see point „Delay Time Setting‟)
" to set temperature ,use "
-Press"
" to start baking
-Press"
Notice: The delay time is the continuation of clock time. For example, if the current time is 10:00 and you
want appliance start working after 2 hours, you should set delay time at 12:00, Press the"
waiting for confirmation .
7.4 Delay time
When " " is pressed to define a delayed start time the corresponding light "
The screen shows the current time"AUTO".Press"
minutes, use" " and"
Press " " to confirm the delayed start time. After pressing "
working.
Screen shows the delayed start time 、Auto and the current time alternately when the appliance is in
standby.
Press " " for 1 seconds if you want to cancel the selected function.
7.5 Pause in the process of baking
Stop baking and change the parameters
 Press the" "start/pause button, can be in baking process stop baking, at this time can be adjusted
in the process of baking time and temperature.
 Press the
" "
standby function key, enter the function menu selection mode, the choice of function.
 Press the
" "
baking time set key, then press the parameter adjustment increase key
" "
the key set cooking time.
 Press the
" "
adjust function keys, switch to baking temperature setting mode;
 Press " "to continue baking.
End baking and cancel the program
 In each function after baking, electronic board buzzer "drop, drop, drop" ring 3 sound, screen shows
"End" (End) scintillation display, in 5 minutes intervals of 30 seconds buzzer"drop, drop, drop" ring
3 sound, screen shows "End" has been flashing, 5 minutes after the prototype into standby state; Or
press the" "start/pause button, prototype into standby mode.
 In the setup program or in the working process of the press
stop work and prototype into standby mode, and then press
(screen display only
7.6 Demo function
The oven in standby state, press and hold
on the screen OFF SHO, namely demo function is inactive. According to the parameter adjustment
" "
increase key and reduce the key
according to the parameters adjustment increase key
demonstration function (OFF SHO); Demo function mainly is convenient sales personnel, the normal
use of the oven, should be set to OFF SHO; Set the parameters of the need, press the clock Settings key
" "
return to the initial oven standby mode.
7.7 Child Lock
Lock: In waiting state, press"
children-lock state and "
display "Block for 3 seconds, and then return to the previous interface
"," " will light up ,30:00 and 180℃ will appear on the screen.
" and"
" and "
" to set minutes,
" "
)
" "
, namely active demonstration function (ON SHO); Then
"for 3 seconds, there will be a long "beep", denoting entering into the
" indicator will light. No matter in any case after lock, screen will always
"to increase or decrease baking time (89 minutes and
" will light (For further information about
"to increase or decrease the desired temperature
" and " " to set hours, Press"
"
" "
standby function keys and
" "
and reduce the key
7
" starts to blink.
"again the appliance starts
"
standby function keys 1 seconds, to
" "
, prototype into shutdown state
" "
set up key to appear
" "
, namely close
" key
"again to set
" "
and reduce
V.1