Device Disposal - FAR FHU 5000 Instrucciones De Uso

Dispositivo oleoneumatico ensamblado con cabezas para remachar elementos de fijacion estructurales

Idiomas disponibles

FHU 5000

TOPPING UP ThE OIL-DYNAMIC CIRCUIT

Verify periodically (15000 cycles), that the oil level does not go below 3/4 of the limit indicated by the proper indicator

up the circuit, remove the plug (h) with a 19-mm wrench, then pour hydraulic oil hLP 32 CST, until it reaches the edge of the threaded hole.

WARNING! The mismaintenance of the oil dynamic circuit will cause a stroke decrease that will lead the disfunction of the tool. Therefore, eliminate the

air in the oil dynamic circuit and restore the exact oil level. Proceed as follows: to prevent any oil loss put the tool on a container and hold the upper side

of the booster on the same level of the gun/and lay the feed hoses as the picture shows. Remove the oil screw cap (h) , and the service cap (E) using for

H a 19 mm wrench and for the other components the appropriate wrenches provided with the tool. Pour oil hLP 32 cSt until it flows from the hole, free

from plug (E), completely free from air bubbles. When the operation has been carried out, replace the plug (E) and make sure that oil has reached the

border of the threaded hole. Screw the screw cap (h) and clean carefully the riveting tool from overflowed oil. It is very important to apply carefully to the

instructions and always wear gloves when you handle the tool. Overflowed oil ,during the topping, must be collected in proper containers and delivered

afterwards, to specialized waste oil getthering company . Do not smash or cut the connecting hoses between gun and booster. Before using the riveting

tool, effect some idling cycles and verify if the level is steady.

BEFORE DISCONNECTING THE COMPRESSED AIR HOSE, MAKE SURE THAT IT IS NOT UNDER PRESSURE.

19 mm

WARNING: Make sure that the oil

filler cap (E) is tightened at a torque

corresponding to

min. 5 Nm ÷ Max. 8 Nm.