5. Wash any dirt or other material from the debris fi lter. Make sure
the drain pump propeller behind the debris fi lter is not blocked.
6. To assemble the fi lter cap, align the projected part of the fi lter cap
to your 12 o'clock (on an imaginary clock) and turn it clockwise.
7. Replace the debris fi lter cap.
8. Replace the fi lter cover.
CLEANING THE DOOR SEAL
1. Open the washer door and remove any clothing or items from the washer.
2. Inspect the gray colored seal between the door opening and
the basket for stained areas. Pull back the seal to inspect all
areas under the seal and to check for foreign objects.
3. If stained areas are found, wipe down these areas of the seal, using the procedure that
follows.
a) Mix a dilute solution, using ¾ cup (177 mL) of liquid chlorine bleach, and 1 gal. (3.8 L) of
b) Wipe the seal area with the dilute solution, using a damp cloth.
c) Let stand 5 minutes.
d) Wipe down area thoroughly with a dry cloth and let the washer interior air dry with door
IMPORTANT:
•
Wear rubber gloves when cleaning for prolonged periods.
•
Refer to the bleach manufacturer's instructions for proper use.
PRESERVING THE TOP COVER AND THE FRONT FRAME
Do not place any heavy or sharp objects or a detergent box on the washer. Keep them in the purchased
pedestal or in a separate storage box.
This may scratch or damage the top cover. There is also a danger of the box or object falling.
CAUTION
Since the entire washer has a high-gloss fi nish, the surface can be scratched or damaged. Therefore,
avoid scratching or damaging the surface when using the washer.
WF350ANP-02833D-03_EN.indd Sec5:27
WF350ANP-02833D-03_EN.indd Sec5:27
warm tap water.
open.
cleaning and maintaining your washer _27
seal
2012-05-04
2012-05-04
7:05:39
7:05:39