Homelite HLCA80710 Manual Del Operador página 13

ATTACHING INJECTION HOSE
See Figure 6.
Before detergent can be used with this machine, the injection
hose must be attached.
Push the open end of the clear injection hose securely

over the fitting as shown in
 Place the filtered end of the injection hose in the bottle
of detergent.
ASSEMBLING THE TRIGGER HANDLE
See Figure 7.
To attach the spray wand:
Place the threaded end of the spray wand in the connector

on the end of the trigger handle.
Turn the connector clockwise until it stops. This

the spray wand in place.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 8.
 Screw the collar on the high pressure hose into the
trigger handle inlet coupler by turning the hose collar
clockwise.
 Pull on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE TO
THE PUMP
See Figure 9.
After the high pressure hose has been uncoiled and attached
to the spray wand:
Align the collar on the threaded nipple on the pump.

Insert the end of the high pressure hose collar into the

threaded nipple.
ASSEMBLY
figure 6.
secures
Page 9 — English
Turn the collar clockwise to tighten the hose securely to

the pump.
Pull on the hose to be certain it is properly secured.

CONNECTING THE GARDEN HOSE TO THE
PRESSURE WASHER
See Figure 10.
CAUTION:
Always observe all local regulations when connnecting
hoses to the water main. Some areas have restrictions
against connecting directly to public drinking water sup-
ply to prevent the feedback of chemicals into the drinking
water supply. Direct connection through a receiver tank
or backflow preventer is usually permitted.
The water supply must come from a water main. NEVER
use hot water or water from pools, lakes, etc. Before
connecting the garden hose to the pressure washer:
Run water through the hose for 30 seconds to clean any

debris from the hose.
 Inspect the screen in the water intake.
If the screen is damaged, do not use the machine until

the screen has been replaced.
 If the screen is dirty, clean it before connecting the garden
hose to the machine.
To connect the garden hose to the machine:
 Uncoil the garden hose.
NOTE: There must be a minimum of 10 feet of
unrestricted hose between the pressure washer intake and
the hose faucet or shut off valve (such as a "Y" shut off
connector).
 With the hose faucet turned completely off, attach the
end of the garden hose to the water intake. Tighten by
hand.