Area Of Application; General Information; Installation Instructions - Westfalia 329 071 Instrucciones De Montaje

Towing hitch
GB
Manufacturer: WESTFALIA-AUTOMOTIVE GmbH
Approval no. as per Guideline 94/20/EC:
Class: A50-X
Technical data:

Area of application:

General information:

The vehicle manufacturer's specifications regarding trailer load and nose weight are deci-
sive for driving, and the values specified for the towing hitch must not be exceeded.
The towing hitch serves for towing trailers fitted with ball couplings and for use with load carriers
approved for attachment to the towing hitch. Any use other than that specified is prohibited. Driving
with a trailer must be adapted to the road conditions. The vehicle's handling is affected when a trailer
is being towed. Follow the vehicle manufacturer's instructions.
The fixing points specified as standard must be observed.
National guidelines concerning official approval of auxiliaries must be observed.
These installation and operating instructions must be enclosed with the vehicle papers.

Installation instructions:

The towing hitch is a safety component and must only be installed by qualified personnel.
Any alteration or conversion to the towing hitch is prohibited, and would lead to cancellation of
design certification.
Remove insulating compound and underseal from vehicle (if present) in the area of the mat-
ing surfaces of the towing hitch. Seal any bare bodywork and bores with anti-corrosive paint.
Operating instructions:
Again tighten all securing bolts of the towing hitch after approx. 1000 trailer km, observing speci-
fied tightening torques.
The towing hitch must be kept clean and greased. However, if a stabilisation device, e.g.
Westfalia "SSK", is used, the towing hitch must be free from grease. Follow the instructions in
the relevant operating instructions.
As soon as the towing hitch diameter is 49.0 mm or less at any point, it must no longer be used
for safety reasons.
After the towing hitch is fitted, the empty weight of the vehicle increases by 4 kg.
Installation instructions
Screw the ball plate onto the vehicle or onto tow hook with M10 screws of property class 10.9, tighten
washers and M10 nut of property class 10. The following screwing combinations are allowed:
a + b + c + d, c + d + e + f, g + h + i + k, a + b + e + f, a + b + c + d + e + f
Tightening torque:
10
Model:
Maximum D-value:
Maximum nose weight: 150 kg
For motor vehicles with dead-end transverse girders or class F tow
hooks that have a factory-made 56x83, 83x112 or 83 x 56/56 mm hole
pattern.
for M 10 = 55 Nm + 10 %
Without electrical set
e13 00-1176
329 071
17,5 kN
Westfalia order no.: 329 071
329 072
Subject to alteration.