Area Of Application; General Information; Installation Instructions - Westfalia 329 064 Instrucciones De Montaje

Towing hitch
GB
Manufacturer: WESTFALIA-AUTOMOTIVE GmbH
Approval no. as per Guideline 94/20/EC:
Class: F
Technical data:

Area of application:

This tow hook may be fitted with towing hitches (e.g. A50-X class) and bolt couplings (e.g., C50
class).
The coupling point clearance of the towing hitch or the bolt coupling has to be at least 65 mm
and no more than 155 mm to the rear of the screw-down area. The clearance from the upper
mounting points "b" has to be a maximum of 40 mm above and 95 mm below.

General information:

The vehicle manufacturer's specifications regarding trailer load and nose weight are deci-
sive for driving, and the values specified for the towing hitch must not be exceeded.
The tow hook may only be used for towing trailers when fitted with a towing hitch or an automatic
bolt coupling and a matching towbar ball receptacle or towbar eye on the trailer. Only trailers
which have been approved may be used with a towing hitch. Unauthorised forms of use is
forbidden. Operation has to be adapted to the road conditions. Vehicle handling changes when
driving with a towed vehicle. The operating manual of the vehicle's manufacturer must be read
and followed.
The fixing points specified as standard must be observed.
National guidelines concerning official approval of auxiliaries must be observed.
These installation and operating instructions must be enclosed with the vehicle papers.

Installation instructions:

The towing hitch is a safety component and must only be installed by qualified personnel.
Any alteration or conversion to the towing hitch is prohibited, and would lead to cancellation of
design certification.
Remove insulating compound and underseal from vehicle (if present) in the area of the mat-
ing surfaces of the towing hitch. Seal any bare bodywork and bores with anti-corrosive paint.
Operating instructions:
Again tighten all securing bolts of the towing hitch after approx. 1000 trailer km, observing speci-
fied tightening torques.
After the towing hitch is fitted, the empty weight of the vehicle increases by 3,5 kg.
14
Without electrical set
Model:
Maximum D-value:
Maximum nose weight: 120 kg
For motor vehicles with dead-end transverse girders or class F
tow hooks that have a factory-made 56x83 mm hole pattern.
Westfalia order no.: 329 064
e13 00-1210
329 064
18,5 kN