Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
User Manual
11.- Tools Menu
11.1.- Default value
This function will replace all the parameters that have been entered with the
factory-established default parameters.
If you wish to reset your receiver to its original ex-factory condition,
select the "Default Value" option and press the OK button. To execute
this operation your password will be required.
An information message will appear on screen. To accept, press OK on
the "Yes" option.
Note: Every time you execute the "Default Value" function, all the informa-
tion and data entered by the user will be automatically erased and
replaced by factory-defined configurations.
After executing the "Default Value" function it is necessary to turn the
receiver off and turn it on again, using the back panel switch so that it
regains all its functions.
11.2.- Software upgrade
If you wish to use the same software and the same channel list on several
receivers, you can duplicate it (by inter-receiver transfer) simply by using an
RS-232 "Null Modem" (female/female) cable connection.
After connecting both receivers with the RS-232 cable, you should follow
the instructions below.
Turn on the "Master" receiver (the receiver possessing the software and
the list of channels to be transferred), using the switch at the back.
Access the option "Software Upgrade", and press the OK button to start
communication.
Now turn on the "Slave" receiver (the receiver you wish to update) using
the switch at the back.
The update will take a few minutes. Please wait until it is complete.
Once the transfer process has ended, you must turn off and restart the
receiver to initiate the new configuration.
Note: Once you have executed the option "Default Value" on the "Slave"
receiver, it will lose the current channel list and adopt instead the
default channel list corresponding to the main "Master" receiver.
61
"RSD - 7118"
Publicidad
Capítulos
Tabla de contenido
