Maintenance; Moisture Condensation - JVC KW-AVX810 Manual De Instrucciones

Maintenance

How to clean the connector
Frequent detachment will deteriorate the connectors.
To minimize this possibility, periodically wipe the
connectors with a cotton swab or cloth moistened with
alcohol, being careful not to damage the connectors.

Moisture condensation

Moisture may condense on the lens inside the unit in
the following cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the unit may malfunction. In this
case, eject the disc and leave the unit turned on for a
few hours until the moisture evaporates.
How to handle discs
When removing a disc from its case, press down the
center holder of the case and lift the disc out, holding it
by the edges.
• Always hold the disc by the edges.
Do not touch its recording surface.
When storing a disc into its case,
gently insert the disc around the center holder (with the
printed surface facing up).
• Make sure to store discs into the cases after use.
A dirty disc may not play correctly.
If a disc does become dirty, wipe it with
a soft cloth in a straight line from center
to edge.
• Do not use any solvent (for example, conventional
Connectors
New discs may have some rough spots
around the inner and outer edges. If
such a disc is used, this unit may reject
the disc.
To remove these rough spots, rub the edges with a
pencil or ball-point pen, etc.
Center holder
66
To keep discs clean
record cleaner, spray, thinner, benzine, etc.) to clean
discs.
To play new discs
Do not use the following discs:
SingleCD—8 cm (3-3/16")
disc
Sticker and sticker residue
Unusual shape
Transparent or semi-transparent on its recording area
Warped disc
Stick-on label
C-thru Disc
(semi-transparent disc)