Timer Operations - Aiwa XR-EM70 Manual De Instrucciones

To prevent accidental erasure
Break off the plastic tab of the cassette tape with a screwdriver
or other pointed tool.
En
Side A
Type II tape
detection
slot
To record on the tape again, cover the tab openings with
adhesive tape. (On type II tapes, take care not to cover the
type II tape detection slot.)
16

TIMER OPERATIONS

POWER
6STANDBY/ON
Tab for side
A Sleep timer
Turns off the unit automatically after a specified time.
1 Hold down SHIFT and press SLEEP on the remote
control.
"SLEEP" is displayed.
2 Press f or g repeatedly to set the sleep
timer duration.
With each press, the timer duration changes in 5-minute
steps between 5 to 240 minutes. If there is no button input
for 8 seconds, the current setting is entered automatically.
The unit turns off after the selected time.
To check the remaining time until the unit turns off
Hold down SHIFT and press SLEEP on the remote control.
The remaining time is displayed for 8 seconds.
To cancel the sleep timer
Hold down SHIFT and press SLEEP on the remote control
repeatedly so that "SLEEPoFF" is displayed.
SET
POWER
f,g
TIMER
f
SHIFT
Timer playback
Turns on the unit at a specified time for the specified duration.
Make sure the clock is set correctly.
1 Hold down SHIFT and press TIMER on the remote
control repeatedly so that "5" lights up and
"5 PLAY" is displayed.
2 Within 8 seconds, press SET.
3 Press f or g to set the timer-on time, and
press SET.
Each press changes the time in 1-minute steps.
Holding these buttons down will vary the time in 10-minute
units.
4 Press f or g to select the source, and press
SET.
•For timer play of a CD, select "CD".
•For timer play of a tape, select "TAPE".
•For timer play of a radio broadcast, select "TUNER".
You will select the band later in step 7.
•For timer play of the equipment connected to the AUX
IN jacks, select "AUX".
SET
SLEEP
g