Information About These Operating Instructions; Symbols Used In These Instructions; Product Description; Intended Use - Oase DMX 02 Instrucciones De Uso

Translation of the original Operating Instructions
1

Information about these operating instructions

Welcome to OASE Living Water. You made a good choice with the purchase of this product Underwater LED
Driver /DMX/02.
Prior to commissioning the unit, please read the instructions of use carefully and fully familiarise yourself with
the unit. Ensure that all work on and with this unit is only carried out in accordance with these instructions.
Adhere to the safety information for the correct and safe use of the unit.
Keep these instructions in a safe place! Please also hand over the instructions when passing the unit on to a
new owner.
1.1

Symbols used in these instructions

The symbols used in this operating manual have the following meanings:
Risk of injury to persons due to dangerous electrical voltage
This symbol indicates an imminent danger, which can lead to death or severe injuries if the appropriate meas-
ures are not taken.
Risk of personal injury caused by a general source of danger
This symbol indicates an imminent danger, which can lead to death or severe injuries if the appropriate meas-
ures are not taken.
Important information for trouble-free operation.
A Reference to one or more figures. In this example: Reference to Fig. A.
→ Reference to another section.
2

Product Description

A, B
Underwater LED Driver /DMX/02 - hereinafter referred to as "unit" - is intended for operating DMX-RDM capa-
ble LED spotlights.
• The unit can be installed underwater and is also suitable for dry installation.
• Up to four DMX/RDM capable LED spotlights can be connected to the unit and individually controlled.
• The PowerBox 24V DC is connected to the power supply. For this, a controlled switching power pack (e.g.
Underwater Power Supply 250 24V/01 from OASE) is required.
• The DMX-Box is connected to an RDM capable controller via the DMX/RDM bus (e.g. WECS from OASE).
2.1

Intended use

Underwater LED Driver /DMX/02, referred to in the following as "unit", may only be used as specified in the fol-
lowing:
• For use above and under water.
• Operation under observance of the technical data.
• Connection of OASE Profi LED spotlights if their operation with the Underwater LED Driver is permitted.
(→ Instructions for use of the LED spotlight)
- GB -
17