Addressing Via Dmx-Rdm; Rdm Parameter For Underwater Led Driver/Dmx/02; Rdm Parameters For Led Spotlights - Oase DMX 02 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

- GB -
5.2

Addressing via DMX-RDM

RDM (Remote Device Management) is a new, open and bi-directional protocol standard for DMX-controlled
devices. The permanently transmitted DMX data flow briefly pauses (several milliseconds), and an RDM data
package (message) is sent directly to a subscriber. The subscriber evaluates the information in the data pac-
kage and sends an answer (semi-duplex) on the same line. Targeted polling to a subscriber via its UID (Uni-
que ID) prevents several subscribers from answering simultaneously.
The protocol makes it possible to receive status information about a unit or to change configurations on a unit.
Changing the configuration means, e.g. changing the DMX address. The prerequisite for this function is a
RDM-compatible controller. Read the corresponding operating instructions
Individual or shared control of the unit outputs is possible. Different operating modes are possible. The opera-
ting mode can only be configured by means of the Personality ID via RDM.
5.2.1

RDM parameter for Underwater LED Driver/DMX/02

General parameters
STATUS_MESSAGES
SUPPORTED_PARAMETERS
PARAMETER_DESCRIPTION
DEVICE_INFO
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
DEVICE_LABEL
SOFTWARE_VERSION_LABEL
DMX_START_ADDRESS
SENSOR_DEFINITION
SENSOR_VALUE
IDENTIFY_DEVICE
DEVICE_HOURS
RESET_DEVICE
PERSONALITY_ID
5.2.2

RDM parameters for LED spotlights

General parameters
STATUS_MESSAGES
SUPPORTED_PARAMETERS
PARAMETER_DESCRIPTION
DEVICE_INFO
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
DEVICE_LABEL
SOFTWARE_VERSION_LABEL
DMX_START_ADDRESS
SENSOR_DEFINITION
SENSOR_VALUE
IDENTIFY_DEVICE
DEVICE_HOURS
LAMP_HOURS
22
GET
SET
Description
CMD
CMD
Used to manage status messages
Overview of all RDM parameters
Description of all parameters
Brief overview of the most important features
Type designation
Manufacturer's designation
Labelling field
Firmware version number
Only relevant and editable for the subdevice
Sensor information
Value of sensor 1: Current operating voltage
0 = Normal mode
1 = LEDs light up in quick succession in the order: Red (R), green (G), blue (B)
Current operating hours
Executes a reset.
1 = warm start
1 = RGB (Red-Green-Blue)
2 = RGBW (Red-Green-Blue-White)
3 = RGB stroboscope
4 = RGBW stroboscope
GET
SET
Description
CMD
CMD
Used to manage status messages
Overview of all RDM parameters
Description of all parameters
Brief overview of the most important features
Type designation
Manufacturer's designation
Labelling field
Firmware version number
Only relevant and editable for the subdevice
Sensor information
Value of sensor 1: Current operating temperature
0 = Normal mode
1 = LEDs light up in quick succession in the order. Red (R), green (G), blue (B)
Current operating hours
Current operating hours of the LEDs in operation

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

50720

Tabla de contenido