Installing Hdm-2B Models - Hatco DRAWERMAX HDM Serie Manual De Instalación Y Funcionamiento

Installing HDM-2B Models

HDM-2B models are built-in units that require installation into a
cabinet before operation.
1. Cut the appropriate opening in the cabinet. Refer to the
illustration below for dimensions.
Front View
721 mm
(28-3/8")
489 mm
(19-1/4")
Locking
Strip
25 mm
(1")
Locking
Strip
3.2 mm
0.125"
22.2 mm
0.875"
Figure 8. Cutout and Locking Strip Dimensions
NOTE: Maintain a minimum clearance of 25 mm (1") between
the cutout opening and the floor.
2. Fasten a locking strip (not supplied) to the lower front
inside lip of the cabinet opening.
3. Make sure a properly grounded electrical receptacle of the
correct voltage, size, and plug configuration is installed
inside the cabinet cutout. See the SPECIFICATIONS
section for details.
Form No. HDMCEM-1010
4. Plug the power cord on the unit into the electrical
5. Partially insert the unit into the opening, making sure the
6. Before installing the unit into the opening completely, apply
Side View
7. Slide the unit into the opening until the front locking studs
603 mm
(23-3/4")
7
receptacle.
power cord is fed into the opening first.
a bead of National Sanitation Foundation-approved sealant
between the drawer warmer flange and the cabinet facing.
drop behind the locking strip. To verify installation, pull out
bottom drawer completely and gently pull to ensure the unit
is locked in place.
Cabinet
Facing
Drawer
Warmer
Flange
Figure 9. Built-In Installation
INSTALLATION
Locking
Strip
Locking Studs
(underneath)