Cameo XNODE 4 Manual De Usuario página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 83
INDEPENDENT UNIVERSES
This setting is only available with firmware versions that appeared before version 1.01. Newer firmware versions provide the same
functionality when the Art-Net version is set to Art-Net 4. The main advantage of the Art-Net 4 support over the obsolete independent univer-
ses functionality is that Art-Net 4 support allows an Art-Net 4 aware controller to properly understand and, if supported by the controller,
configure the port address of each port whether the ports share a common net and sub-net address or not.
Independent Art-Net universes may be enabled and disabled under Home > Menu > Art-Net > Independent Universes. If independent Art-
Net universes are enabled, the ports of the Art-Net node do not need to share the same Art-Net net and sub-net addresses.
When this feature is enabled, each output port has an independent port address in the range of 0 to 32767, which is computed from the Art-
Net net, sub-net and universe number. This allows for configuring the node to any combination of Art-Net universes. However, if the Art-Net
net or the Art-Net sub-net settings are changed (remotely or in the menu), each output port address is recomputed. For more information on
the addressing of the Art-Net ports, see section Representations of Art-Net Port Addresses in the appendix.
Unfortunately, due to restrictions of Art-Net, the node may no longer correctly report the port addresses of its outputs to a controller when
this feature is enabled, which might confuse a controller and lead to problems. Therefore, it is recommended to avoid enabling independent
universes whenever possible.
NAME
The device name can be viewed and edited under Home > Menu > Art-Net > Name.
DELETING TEXT
To delete a text line or a part of it, position the cursor immediately to the left of the first character you want to have deleted.
Then keep [OK] pressed and turn the encoder clockwise until all of the text that you wish to delete appears highlighted.
As you release the [OK] button, the highlighted text is removed.
INSERTING OR APPENDING TEXT
To append or insert text, move the cursor to the position where you want to add your text.
12

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Clxnode4

Tabla de contenido