English; Safety Information; Safety Precautions - Cameo XNODE 4 Manual De Usuario

ENGLISH

YOU HAVE MADE THE RIGHT CHOICE!
This device was developed and produced under the highest standards of quality in order to ensure smooth operation for many years. Please
read these operating instructions carefully so that you can use your new Cameo Light product quickly and optimally. You can find more
information on Cameo Light on our website WWW.CAMEOLIGHT.COM.

SAFETY INFORMATION

It is essential that you read and understand this manual before operating the device and that you follow the instructions given below closely
when you set up, connect and use the XNODE 4. Do not use the device in any way or for any purpose not described in this user manual.
This product is approved for professional use only; it is not intended for household usage. Pay attention to all warnings given in this manual
and use this device only in accordance with applicable laws and regulations.

SAFETY PRECAUTIONS

• Disconnect the device from the AC power supply before removing any cover or part, including fuses, even when not in use.
• Ensure that the device is electrically connected to ground (earth).
• Use only a source of AC power supply that complies with local building and electrical regulations and which has both overload and
ground-fault (earth fault) protection.
• Before using the device, check that the power distribution equipment and cables are in perfect condition and rated for the current required
by all connected devices.
• Isolate the device from power supply immediately if the power cable or the power plugs are in any way damaged, defective or wet, or if
they show signs of overheating.
• Do not expose the device to rain or moisture.
• Do not operate the device if any cover or component is missing, damaged or deformed.
• Refer any service operation not described in this manual to Cameo.
• Provide unrestricted airflow around the device.
• Do not operate the device if the ambient temperature exceeds 55°C (131°F).
• Do not modify the device in any way not described in this manual or install other than genuine Cameo parts.
• Do not attempt to bypass any fuse. Replace any defective fuse with one of the specified type and rating only.
• When suspending the device, ensure that the supporting structure and all hardware used can hold at least 10 times the weight of all
devices suspended together.
• When suspending the device, install a secondary attachment such as a safety cable that is approved by an official body such as, e.g.
TÜV (German Technical Monitoring Association), a safety attachment for the total weight it secures. The safety cable must comply with
EN 60598-2-17 section 17.6.6 and be capable of bearing a static suspended load 10 times the weight of the device.
• Make sure that any external cover and rigging hardware is securely fastened.
• Provide an adequate clearance underneath the work area and a stable platform whenever installing, servicing or moving an overhead device.
• Do not use the device in areas where it is exposed to direct sunlight.
• Do not use the device in areas that are "highly inflammable".
CAUTION! IMPORTANT INFORMATION ABOUT LIGHTING PRODUCTS!
1. The product has been developed for professional use in the field of event technology and is not suitable as household lighting.
2. Do not stare, even temporarily, directly into the light beam.
3. Do not look at the beam directly with optical instruments such as magnifiers.
4. Stroboscope effects may cause epileptic seizures in sensitive people! People with epilepsy should definitely avoid places where
strobes are used.
3