Network Settings - Cameo XNODE 4 Manual De Usuario

STATUS INDICATION
There are several indicators and labels on the Port Screen to show the current operating mode and the state of the selected port. The
following status labels displayed on the upper left of the Port Screen show the DMX signal status:
Label Port Mode
in, out
in, out
out
in
To show additional information about the selected port, there are status indicators for the presence of RDM on output ports, as well as the
merge mode and status on the upper right of the display. These status indicators are only available with Art-Net 4 and sACN.
Indicator Port Mode
out
out
out
in
Indicator Port Mode
out
out
out

NETWORK SETTINGS

The network settings can be found under Home > Menu > Network or by double tapping the Ethernet port button.
All following settings can also be changed via web interface on the Network Settings Page.
DHCP
Navigate to Home > Menu > Network > DHCP in order to enable or disable DHCP (Dynamic Host Configuration Protocol). Choose Enable
if you want to have your network configured by a DHCP server. This would typically be the case if you connect the XNODE 4 to a home or
office network.
A bullet point is shown next to the currently active setting. Use the encoder wheel to choose the desired setting and confirm by pressing
[OK] in order to change the setting.
• 6 seconds for firmware version 0.93 and earlier
1
Description
No DMX signal present.
A valid DMX signal is detected.
Port is outputting a look which has been received before, but no updates have been received
for at least 10 seconds .
1
An error on the DMX signal appeared.
Description
Receiving signal from one source.
Receiving signal from two sources. Merger active.
Receiving signal from more than two sources. See section Merge Mode.
Sending signal to broadcast or multicast address.
Description
Art-Net RDM is enabled.
Merger mode is HTP. See section Merge Mode.
Merger mode is LTP. See section Merge Mode.
9