KENMORE ELITE 66513153K701 Instrucciones De Instalación página 14

Connect to water supply
Helpful Tip:
Compression fittings:
a. Slide nut onto copper tubing about 1" (2.5 cm).
b. Slide ferrule onto the tubing. Do not position ferrule
on the end of the tubing.
c. Put the tubing into the elbow as far as it will go.
d. Slide the nut and ferrule forward and start the nut
onto the elbow threads. Be gentle when handling
and positioning the copper tubing, it bends and kinks
easily.
ferrule
elbow _ _1
ut
To prevent vibration during operation, route the water
supply line so that it does not touch the dishwasher
base, frame or motor.
With copper tubing pushed
into compression fitting as .......
far as it will go, use a
wrench and tighten
compression fitting nut to ............
elbow on water inlet valve.
Place paper towel under elbow.Turn on water supply
and check for leaks.
Connect to drain
3=
4.
To help minimize /' I
vibration, route drain
hose to avoid contact
with motor, door springs,
water line, cabinet,
flooring or the edge of
the hole where it passes
through the cabinet.
Do not remove drain
loop from side of
dishwasher.
Place pan under end of
drain hose. Pan will collect any water in drain hose.
Place the smaller drain hose clamp onto the small end
of the drain hose.
j hose clamp
Push the drain hose into the connector up to the stop
on the drain hose.
connector stop
6. Use pliers to open clamp and slide clamp onto
connector between stops on connector as shown.
Secure dishwasher in cabinet opening
Tip Over Hazard_
Do not use dishwasher until completely installed._
Do not push down on open door._
Doing so can result in serious injury or cuts,
1. If you have not already done so, open dishwasher door
and place towel over pump assembly and spray arm of
dishwasher.This will keep screws from falling into
pump area if you unintentionally drop them when
securing dishwasher to countertop.
2. Check that dishwasher is still level and centered side to
side in the opening.
3. Secure dishwasher to countertop or sides of cabinet
with two, #10 x 1/2" Phillips-head screws.The
dishwasher must be secured to keep it from tipping
when door is opened.
4=
5=
Open door about 3 inches (7.6 cm) and check that space
between inner door and tub is equal on both sides. If
spacing is not equal, loosen bracket screws and shift
tub.Tighten bracket screws.
Check that top of door does not contact screws,
brackets, or countertop. If it does, dishwasher must be
6=
7.
8.
lowered and re-leveled.
If securing
to sides of cabinel replace the plastic
plastic -___'
button
buttons.
Remove towel from dishwasher.
Reinstall the lower dishrack.
stops
14