How To Level Your Refrigerator - Sears KENMORE ELITE 596.72282200 Manual De Uso

Installing your refrigerator,
How to level your
refrigerator
If your refrigerator requires an ice maker
water supply connection, proceed to
How to Connect the Water Supply
section (page 9) before leveling your
refrigerator.
CAUTION
To protect personal property or
refrigerator from damage, observe the
following:
Protect soft vinyl or other flooring
with cardboard, rugs, or other
protective material.
Do not use power tools when
performing leveling procedure.
10
cont.
MATERIALS NEEDED
" hex head driver
3
⁄
8
Level
1. Remove toe grille and bottom bracket
covers.
2. Turn left and right
adjustment screws
(A) to raise or
lower front of
refrigerator.
Make sure
refrigerator
cabinet is level from side to side
by adjusting left and right roller
adjustment screws.
Turn stabilizing leg clockwise until
firmly against floor.
3. After completing the above listed
steps, turn roller adjustment screws
(A) 2 to 3 times counterclockwise, so
that full weight of refrigerator rests on
stabilizing legs.
4. Using a level, make sure front of
refrigerator is
higher than back of refrigerator.
See step 3 for assistance.
5. Replace toe grille and bracket covers.
See markings on inside of toe grille to
insure proper placement.
Snap bottom portion into place
A
first. Press down on top part of
grille until top portion snaps into
place.
" (6 mm) or bubble
1 1
⁄ ⁄
4 2