Nelson EZ PRO Serie Guia De Instalacion página 10

INSTALLATION INSTRUCTIONS
Connecting the batteries and starting the controller
Remove the battery access door from the rear panel. Insert two new AA Alkaline (LR6 in
Europe) batteries to the battery clips and install the battery access door. The batteries enable
the EZ Pro™ to be programmed without AC power and maintain the real time clock in the
event of a power outage. If the batteries are not installed, the controller will lose real time in
the event of a power outage. The batteries should be replaced once a year.
NOTE: Since all programs are stored in non-volatile memory, you will not lose program
settings during a power failure - even if there is no battery installed.
CAUTION: Use AA alkaline batteries only. An AA NiCad battery may leak or explode causing
personal injury or property damage.
Close the front panel, being sure not to damage wires. If wires are stiff, you may find it helpful
to pre-bend them. Turn on the power source.
You're now ready to start programming!
8