Rops Installation - Husqvarna MZ54 Manual Del Operador

ASSEMBLY
NOTE: For illustration purposes, the unit is
shown with parts removed. No disassembly is
needed for the following installations.

Rops Installation

1. Secure the side tubes (1) to the frame using
four bolts (2), washers (3) and lock nuts (4),
2. Install the top loop (5) to both side tubes with
two bolts (6) and nuts (7) so that the top loop
folds to the rear of the unit.
3. Insert the ROPS pins (8) into the top loop
brackets to set the desired position. Secure
the lanyard (9) and the ROPs pin (10) on the
opposite side.
5
7
9
10
6
8
4
3
2
4
3
2
WARNING! Keep the ROPS in the
upright locked position and use the seat belt.
When the ROPS must be folded down, do not
use the seat belt and operate with extra care.
12
1