Malfunction causes and remedies
The following table will help with localizing and remedying minor malfunctions:
Defect
Appliance does
not switch on.
UV gel a does not
harden suffi ciently.
After hardening,
a "sweat layer" re-
mains on the nails.
The artifi cial nails
are soft/loosened.
The artifi cial
fi ngernails show
unevenness.
A UV lamp does
not glow.
NOTICE
►
If you cannot solve the problem with the aforementioned solutions, please
contact Customer Services.
SNS 45 A3
Possible cause
The plug is not connected.
Mains power socket does
not supply any voltage.
The selected treatment
time too short.
One or more UV lamps
are defective.
Too much UV gel a
applied.
The nails were not directly
under the UV lamps.
Occurence of a "sweat-
layer" caused by polyme-
rization.
Loosening of the artifi cial
nails by products with a
high acetone concentra-
tion.
Pressure on the brush e
too high when applying
the UV gel a.
UV gel a unevenly applied.
UV lamp defect.
Solution
Insert the plug into the mains
power socket.
Check the fuses.
Select a longer treatment time.
Replace any defective UV lamps (see
chapter entitled "Exchanging UV
lamps")
Apply less UV gel a.
Hold the hand correctly in the
UV appliance 1.
Remove the "sweat layer" with
the fi nishing solution o.
Apply no products with a high
acetone concentration.
Do not press too hard on the brush e
when you are applying the UV gel a.
Apply a further and thinner layer
of UV gel a and then harden it.
Replace the defective UV lamp.
GB
MT
117