BSV BS Pool EVOLINK Serie Manual De Usuario página 101

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

no flow, the production will stop, and an alarm will sound accompanied by a red
warning LED. Once the flow has been reestablished, the equipment will return
to normal operation.
The "Flow Kit" (optional) is necessary to activate the flow sensor, which is
done by pressing Flow Switch = ON.
4.1.4.6- Cover
On placing the cover, the chlorinator automatically reduces production to 20%,
C letter will appear to it, it means cover is activated. This variation will be
reflected in the production %. It can be enabled of disabled by toggling Cover
= ON/OFF.It is considered a normally open contact
If chlorination is carried out with the cover in place, when it is
removed, the pool should not be used straightaway. It is
better to wait ½ hour for any vapours between the water and cover
to dissipate.
4.2.4.8 Acid / Alkali
With this option you can select the type of pH corrector to be used in your
swimming pool.
Attention: It should be selected correctly otherwise the
dosing system will work opposite to expected.
-
Acid: Select this mode if you are going to inject pH reducer into the
swimming pool (default mode). ACID
-
Alkaline: Select this mode if you need to inject pH increaser into the
swimming pool. ALK
Access this option in the "Configuration menu" and go to MORE. To change
this mode to the correct option, press ACID and it will flip to ALK, another
touch it will return to ACID.
4.2.4.8- pH Alarm
The pH adjustment system will give an alarm and the dosing pump will stop
operating when the pump works continuously for more than 2 hours,
This could occur for the following reasons:
Manual EVOLINK v.5
101 / 120

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido