Hilti SCM 22-A Manual De Usario página 23

▶ Check the tool and batteries for damage before use after long periods of
transport.
Storage
CAUTION
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a
window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by
children or unauthorized persons.
▶ Check the tool and batteries for damage before use after long periods of
storage.
8 Troubleshooting
▶ If the trouble you are experiencing is not listed in this table or you are
unable to remedy the problem by yourself, please contact Hilti Service.
8.1 The circular saw is not in working order.
Malfunction
The LEDs indicate
nothing.
1 LED blinks.
4 LEDs blink.
*2153713*
Possible cause
The battery is not fully
inserted.
The battery is
discharged.
The battery is
discharged.
The battery is too hot or
too cold.
The circular saw was
overloaded briefly.
The overheating preven-
tion cut-out has been
activated.
2153713
Action to be taken
▶ Insert the battery.
▶ Charge the battery.
▶ Charge the battery.
▶ Bring the battery to
the correct ambient
temperature.
▶ Release the control
switch and then press
it again.
▶ Allow the circular saw
to cool down to cool
down and clean the
air vents.
English 17