Care And Maintenance; Disposal; Manufacturer's Warranty - Tools - Hilti SD 4500 Manual De Instrucciones

8. Care and maintenance

Unplug the supply cord form the power outlet.
8.1 Care of screwdriving bits and metal parts
Clean off dirt and dust deposits adhering to the surface
of the screwdriving bits, chuck or spindle and protect
these parts from corrosion by wiping them from time
to time with an oil-soaked rag.
8.2 Care of the power tool
The outer casing of the tool is made from impact-resis-
tant plastic. Sections of the grip are made from a syn-
thetic rubber material.
Never operate the power tool when the ventilation slots
are blocked. Clean the ventilation slots carefully using
a dry brush. Do not permit foreign objects to enter the
interior of the power tool. Clean the outside of the power
tool at regular intervals using a slightly damp cloth. Do
not use a spray, steam pressure cleaning equipment or

9. Disposal

Most of the materials from which Hilti power tools are manufactured can be recycled. The materials must be cor-
rectly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking
back your old power tools for recycling. Please ask your Hilti customer service department or Hilti representative
for further information.
10. Manufacturer's warranty – tools
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid so
long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical sys-
tem is maintained. This means that only original Hilti
consumables, components and spare parts may be
used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement
as a result of normal wear and tear are not covered by
this warranty.
Additional claims are excluded, unless stringent
national rules prohibit such exclusion. In particular,
Printed: 07.07.2013 | Doc-Nr: PUB / 5070548 / 000 / 00
running water for cleaning. This may negatively affect
the electrical safety of the power tool. Always keep the
grip surfaces of the power tool free from oil and grease.
Do not use cleaning agents which contain silicone.
8.3 Maintenance
Check all external parts of the power tool for damage at
regular intervals and check that all controls operate fault-
lessly. Do not operate the power tool if parts are dam-
aged or when the controls do not function faultlessly. If
necessary, your power tool should be repaired at a Hilti
repair center.
Repairs to the electrical section of the power tool may
be carried out only by trained electrical specialists.
8.4 Checks after care and maintenance
After carrying out care and maintenance, check the power
tool for correct operation (drive and remove a screw).
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inabil-
ity to use the tool for any purpose. Implied warranties
of merchantability or fitness for a particular purpose
are specifically excluded.
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.
en
7