Carat T-5010 Manual De Instrucciones página 29

1. Use
WARNING !
Read the safety chapter carefully before using
this machine. Each machine is subjected to a
series of tests and carefully checked before
leaving our factory.
Carat Centrale B.V. is constantly striving to
develop their machines and therefore reserves
the right to change such machines. No claims
may therefore be made on the basis of the data
and illustrations contained in this manual.
The T-5010/T-6010 site cutter is a technologically
advanced product suitable for cutting bricks,
poroton, concrete and materials used in building
construction.
2. Precautions
• The manufacturer accepts no responsibility for
use of the T-5010/T-6010 cutter with tools not
indicated in the "CUTTING TOOL" paragraph.
DO NOT USE WOODEN DISCS.
DO
DISCS.
• The T-5010/T-6010 is made to operate
exclusively under the conditions indicated under
"TYPE OF OPERATION ALLOWED", in the
"TECHNICAL DATA" paragraph.
• During cutting operations, allow the machine to
rest as indicated.
• The T-5010/T-6010 is not made to operate
under a continual load.
• This machine is designed to use Ø500 and/or
Ø600 mm discs. For discs with diameters of
more than a few milimetres, it may be
necessary to lock the motor head in a slightly
raised position in order to avoid interfering
with the working surface during cutting.
• ALWAYS TEST THE ROTATION DIRECTION
WITH THE CUTTING DISC REMOVED.
WARNING !
DO NOT USE DIAMOND TIPPED DISCS OF
DETERIORATING QUALITY OR THAT ARE NOT
SUITABLE FOR THE SPECIFIC USE FOR WHICH
THE MANUFACTUERE SUPPLIED THEM.
NOT USE DRY-CUTTING
USE OF DETERIORATING DISCS CAN HARM
THE OPERATOR AND DAMAGE THE MACHINE,
AS WELL AS SIGNIFICANTLY SLOWING THE
WORK.
WARNING !
TO REDUCE THE RISKS ARISING FROM
FRAGMENTATION OF MATERIALS, ALWAYS
USE APPROPRIATE PROTECTIVE GOGGLES.
WARNING !
CONTINUOUS USE OF THIS MACHINE FOR 8
(EIGHT) HOURS RESULTS IN EXPOSURE TO
NOISE EXCEEDING
NECESSARY, THEREFORE,
APPROPRIATE PROTECTIVE HEADPHONES AS
REQUIRED BY LAW.
WARNING !
The following steps are advisable:
• during cutting, allow the carriage to move
slowly, without stopping the disc;
• ensure that the piece to be cut is properly
supported by the tile clamp.
3. Installation
Position the machine on a stable surface.
To set the machine for operating, proceed as
follows:
WARNING !
ENSURE THAT THE MOTOR HEAD IS LOCKED IN
THE LOWERED POSITION USING THE LOCKING
LEVER ON THE SIDE OF THE MOTOR. ENSURE
THAT THE WORKING SURFACE IS LOCKED IN
POSITION BY THE CARRIAGE CLAMP.
1 1
29
GB
85 DB(A). IT IS
TO WEAR