Securing The Product To The Unit Mounting Bracket; Electrical Installation; Connecting The Heat Generator To The Product; Connecting The Product To The Power Supply In A Fixed Installation - Vaillant airMONITOR Instrucciones De Funcionamiento

5 Electrical installation

4.7 Securing the product to the
unit mounting bracket
Conditions: Electrical installation has already been
carried out
A
▶
Secure the product to the unit mounting
bracket as shown in the illustration.
5 Electrical installation
Only qualified electricians may carry out
the electrical installation.
5.1 Connecting the heat generator
to the product
1. Open the product. (→ Page 50)
52
E
B
2. Connect the power supply cable for the
heat generator to the product as shown
in the illustration.
3. Close the product. (→ Page 51)
4. Secure the product to the unit mount-
ing bracket. (→ Page 52)
5.2 Connecting the product to
the power supply in a fixed
installation
If no suitable country-specific earthed plug
socket is available at the installation site,
a fixed connection to the power supply is
required.
▶
Permanently connect the power supply
cable to the on-site power supply via an
all-pole electrical partition which can be
switched off (e.g. a circuit breaker).
– Contact gap of the electrical partition:
≥ 3 mm (≥ 0.12 in)
5.3 Connecting the mains plug to
the power supply cable
▶
Connect a mains plug (not included
in the scope of delivery) to the power
supply cable.
Installation instructions airMONITOR 0020234540_02
L N
B
C
A
D