Delta 50-767 T2 Manual De Instrucciones página 13

ATTACHING THE
DUST COLLECTION BAG
Disconnect the machine from the power source!
A. USING CLOTH COVERED FLEXIBLE RING:
1. Place the cloth-covered bag retainer ring
inside the opening of the clear plastic dust
collection bag. Fold about 6 inches of the bag
around the retainer ring (Fig 14).
2. Place the bag in the large hole in the
blower housing assembly. Fit the retainer
ring into the bottom groove. Bend and
fold the ring to fit it into place. Flexible
ring will fit into the bottom of the blower
housing the same way as described for
installation of the Micron bag in the top of
the blower housing. Refer to Fig 19 & Fig
20 on pg 15.
3. Tug slightly on the bag to eliminate any slack
and to make sure that the bag is secure and
will not detach during collection.
B. USING A METAL BAG CLAMP
You can also attach the plastic bag to the outside
of the dust collector using the included clamp
Fig 15.
1. Slide the bag under the hooks.
2. Place the clamp around the top of the
plastic bag. Folding over a few inches
of plastic bag over the clamp.
3. Secure the clamp making sure the
clamp isn't over the hook.
ASSEMBLY (continued)
13
FIGURE 14
FIGURE 15