Delta 50-767 T2 Manual De Instrucciones página 16

ASSEMBLY (continued)
ATTACHING THE HOSE TO THE INTAKE PORT
Disconnect the machine from the power source!
Model 50-767 T2 provides two 4" dust ports.
To attach the hose (SOLD SEPARATELY):
Loosely attach the hose clamp around one
end of the flexible hose (Hose sold seper-
ately). Attach the hose to the dust intake
port. Tighten the hose clamp as shown in
Fig 21. Attach the remaining clamp to the
other end of the flexible hose and to the
woodworking machine.
NOTE: Do not operate the dust collector
with either dust intake port uncovered.
Place the intake cap on the dust intake port
not being used.
FIGURE 21
16