Makita LS1040 Manual De Instrucciones página 14

There are crown and cove molding joints which are
made to fit "Inside" 90° corners ((1) and (2) in Fig. A)
and "Outside" 90° corners ((3) and (4) in Fig. A).
(1) (2) (3) (4)
1
Fig.A
1. Inside corner 2. Outside corner
1
(2)
(1)
(2)
(1)
► 1. Inside corner 2. Outside corner
Measuring
Measure the wall length and adjust workpiece on table to cut
wall contact edge to desired length. Always make sure that
cut workpiece length at the back of the workpiece is the
same as wall length. Adjust cut length for angle of cut. Always
use several pieces for test cuts to check the saw angles.
When cutting crown and cove moldings, set the bevel angle and
miter angle as indicated in the table (A) and position the moldings
on the top surface of the saw base as indicated in the table (B).
Table (A)
Bevel angle
Molding
position in
52/38° type
Fig. A
(1)
For inside
corner
(2)
Left 33.9°
(3)
For outside
corner
(4)
Table (B)
Molding
Molding edge against
position in
guide fence
Fig. A
Ceiling contact edge should
(1)
be against guide fence.
For inside
corner
(2)
Wall contact edge should be
against guide fence.
For
(3)
outside
corner
Ceiling contact edge should
(4)
be against guide fence.
2
(1)
(2)
(2)
(1)
(4)
(3)
(1)
(2)
Miter angle
45° type 52/38° type 45° type
Right 31.6° Right 35.3°
Left 30° Left 31.6° Left 35.3°
Right 31.6° Right 35.3°
Finished piece
Finished piece
will be on the
Left side of
blade.
Finished piece
will be on the
Right side of
blade.
EXAMPLE In the case of cutting 52/38° type crown
molding for position (1) in Fig. A:
• Tilt and secure bevel angle setting to 33.9°
LEFT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on
the saw.
• The finished piece to be used will always be
on the LEFT side of the blade after the cut has
been made.
2
14 ENGLISH