Checking And Adjusting The Rotation Laser - Hultafors RL Instrucciones De Uso

Instruction:
The height of the detector is similar to the height of the emitting window of the
laser. Face the surface of the detector to the unit, move the detector up and
down until continuous audible sound is heard. (also shown on the LCD display)
Specification: (Receiver)
Range of visible beam:
Display:
Power supply:
Automatic power shut off:
Start/Stop mode
Press this switch to start/stop the rotation.
Point the remote control at the reception window at the top of the rotating laser
device. (There are two reception windows, one at the front and one at the back).
Levelling display
(Green: horizontal, red: not level)
Battery level indication
(Red: batteries need to be replaced)

7. Checking and adjusting the rotation laser

Set up the device at a distance of approx. 20 m from the wall.
Level the device and switch on the laser.
Stop the rotation in such a way that the laser points to the wall.
Then mark this point A.
GB
Fine accuracy: +/- 1mm
Coarse accuracy +/- 2,5mm
LCD double side
DC 9v battery
10 min
18