Symbols; Safety Information; Introduction; Available Versions - Beha-Amprobe EVC-13 Manual Del Usuario

SYMBOLS

� Caution! Refer to the explanation in this manual.
Consult user documentation.
T
The equipment is protected by double insulation or reinforced insulation.
Reference, please pay utmost attention.
Conformity symbol, confirms compliance with the applicable European directives. The requirements
�
of the Low Voltage Directive with the relevant regulations Standards are also fulfilled.
=
Symbol for marking of electrical and electronic equipment (WEEE Directive).

SAFETY INFORMATION

Tests of charging equipment should only be carried out by properly trained and competent persons!
Please carefully read the safety information before using the test cable.
�WARNING
To avoid the possibility of electric shock or personal injury:
• The user manual contains information and references necessary for safe operation and maintenance of the
accessory. Prior to using the accessory, thoroughly read the user manual and comply with it in all sections.
• If the equipment is used in a manner not specified by the manufacturer, the protection provided by the
equipment may be impaired.
• Failure to read the user manual or to comply with the warnings and references contained herein can result
in serious bodily injury or equipment damage.

INTRODUCTION

The EVC-13 and EVC-20 are high-quality accessories manufactured by BEHA-AMPROBE, which will enable you
to perform repeatable measurements for a very long period of time.
These accessories can be used in combination with other test equipment from BEHA-AMPROBE who is
designed to test function and safety of charging equipment for electro vehicles.

AVAILABLE VERSIONS

1 EVC-13 Test Cable for EV charging station cable type 1 with fixed cable and vehicle connector
1 EVC-20 Test Cable for EV charging station type 2 with socket outlet or fixed cable with vehicle connector

TRANSPORT AND STORAGE

Please keep the original packaging for future transport (e.g., if calibration is necessary). Any transport damage
due to faulty packaging will be excluded from warranty claims.
The accessory must be stored in dry, closed areas. In case of an accessory being transported in extreme
temperatures, a minimum recovery time of 2 hours is required prior to any operation.

SAFETY MEASURES

These accessories have been built and tested in compliance with the valid safety regulations and left the
factory in safe and perfect condition. In order to maintain this condition and to ensure safe instrument
operation, the user must pay attention to the references and warnings contained within this user manual.
2