Aligning The Mounting Plate - GE JVM3160RF2SS Instrucciones De Instalación

ALIGNING THE MOUNTING PLATE

D
Hole A
Hole C
CAUTION
Wear gloves to avoid cutting
fingers on sharp edges.
Draw a vertical line on the wall at the center of the 30
1
wide space.
2 Use the mounting plate as the template for the rear
wall. Place the mounting plate on the wall, making
sure that the tabs are touching the bottom of
the cabinet or the level line drawn in Step C for
cabinets with front overhang. Line up the notch
and center line on the mounting plate to the center
line on the wall.
While holding the mounting plate with one hand,
3
draw circles on the wall at holes A, B, C, and D (see
illustration above/actual plate marked with arrows) .
Four holes must be used for mounting.
Installation Instructions
30"
Area E
11
Draw a
Vertical Line
on Wall from
Center of
Top Cabinet
Notch
NOTE: Holes C and D are inside area E. If neither
C nor D is in a stud, find a stud somewhere in area
E and draw a fifth circle to line up with the stud.
It is important to use at least one wood screw
mounted firmly in a stud to support the weight of the
microwave oven.
Set the mounting plate aside.
WARNING
Risk of electric shock. Can cause
injury or death. Take care to not drill into electrical
wiring inside walls or cabinets.
4 Drill holes on the circles. If there is a stud, drill a
hole for wood screws. For holes that don't line up with
a stud, drill a hole for toggle bolts.
5 8
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
Hole B
Hole D
3 16