Arecirculating; Attach Mounting Plate To Wall; Preparation Of Top Cabinet - GE JVM3160RF2SS Instrucciones De Instalación

RECIRCULATING
A
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Install Charcoal Filter (Supplied with AVM4160
and JVM3160 models)
A4. Mount the microwave oven
A5. Installing/Replacing the Charcoal Filter Without
Access to Top Screws and the Unit Has
Already Been Mounted.
A1 ATTACH THE MOUNTING
PLATE TO THE WALL
Attach the plate to the wall using toggle bolts. At
least one wood screw must be used to attach the
plate to a wall stud.
1 Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through
2
the holes designated to go into drywall and
reattach the toggle wings to
To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
Installation Instructions
(Non-Vented Ductless)
onto each bolt.
3 4
Bolt End
Place the mounting plate against the wall and
3
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet or the horizontal
level line when pushed flush against the wall and
that the plate is properly centered under the cabinet.
CAUTION
fingers between the back of the mounting plate
and the wall.
4 Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
A2
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION
Wear safety goggles when
drilling holes in the cabinet bottom.
13
Be careful to avoid pinching
Cooking
Conven ience
Beverag e Potato
Popcorn
Cook
Defrost e Time
Reheat Weight/Tim
Timer
On/Off
Express Cook
Add
3 30 Sec.
1 2
6 Turntabl e
4 5
Surface
8 9 Light
7
Set Vent
Power 0 Clock
Level
Start
Cancel Pause
Off