Outside Back Exhaust; Preparation Of Top Cabinet - GE JVM3160RF2SS Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ATTACH THE MOUNTING PLATE
C2
TO THE WALL (cont.)
To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
3
Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION
Be careful to avoid pinching
fingers between the back of the mounting plate
and the wall.
Tighten all bolts. Pull the plate away from the wall
4
to help tighten the bolts.
C3
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws
and a hole large enough for the power cord to fit
through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION
Wear safety goggles when
drilling holes in the cabinet bottom.
Installation Instructions
Bolt
End
21
ADAPTING BLOWER FOR
C4

OUTSIDE BACK EXHAUST

1 Remove the blower motor screws that holds the
blower plate to the microwave oven. Slide the plate
toward the back of the microwave and lift up to
remove.
Blower Motor Screws
Remove screw on the back of the unit.
2
3
Carefully remove fan from cavity. Remove the wire
from the notch at the bottom of the fan after it is
removed from the cavity.
The fan needs to be turned 180 degrees to the
4
right to be in the correct orientation, keeping
the blower part of the fan where the air comes
out at the top of the fan. The wire needs to be
reinserted into the cage housing once it has been
oriented correctly.
Wires
5 Remove the knockout plates in the back of the
unit with snips.
Back of microwave
Blower
Plate
Screw
Fan Blades
Back of Microwave
Knockout Plates:
Snip all 4 webs on
each knockout panel
and remove the metal
knockouts for rear airflow.
Please take care to
remove any sharp edges
created from removing
the knockout plates.

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Jvm3160df1wwJvm3160df2ccAvm4160Jnm3161Jvm3160Rvm5160

Tabla de contenido