Rotary Hammer Safety Warnings; Standard Accessories; Optional Accessories (Sold Separately) - Hitachi DH 50SA1 Instrucciones De Manejo

English

ROTARY HAMMER SAFETY WARNINGS

1. Wear ear protectors.
Exposure to noise can cause hearing loss.
2. Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
3. Do not touch the bit during or immediately after
operation. The bit becomes very hot during
operation and could cause serious burns.
SPECIFICATIONS
Voltage (by areas)*
Input*
Capacity
No load speed
Full-load impact rate
Weight (without cord, side handle)
* Be sure to check the nameplate on product as it is subject to change by areas.

STANDARD ACCESSORIES

(1) Case ........................................................................... 1
I type: Side handle ...................... 1
(2) Side handle II type: Bar type handle ............... 1
Either type I or type II Side handle is attached.
(3) Stopper (I type Side handle only) ....................... 1
(4) Dust cover ................................................................. 1
(5) Hammer grease A ................................................... 1
Standard accessories are subject to change without notice.

OPTIONAL ACCESSORIES (sold separately)

Through-hole drilling:
(1) Drill bit (hexagon shank)
Total length: 420, 570 mm
External dia.: 16, 18, 20, 22, 25, 28, 30, 32, 35, 38,
40, 44, 50 mm
Anchor hole drilling (Rotation + Striking):
(3) Cotter
(1) K-Taper shank adapter
7
D type handle .................. 1
(2) A-Taper
sleeve
4. Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
5. Always hold the body handle and side handle of
the power tool firmly. Otherwise the counterforce
produced may result in inaccurate and even
dangerous operation.
6. Wear a dust mask
Do not inhale the harmful dusts generated in
drilling or chiseling operation. The dust can
endanger the health of yourself and bystanders.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
1140W
Drill bit: 50 mm
Core bit: 125 mm
300 min
2450 min
9.8 kg
Large-dia. hole boring (Rotation + Striking):
(1) Center Pin (Guide
plate)
(1) Center pin
Applied to core bits from 50 mm to 125 mm.
(2) Core bit
External dia.: 50, 65, 80, 90, 100, 125 mm
(3) Core bit shank
Crushing:
(1) Cold chisel
Total length: 300, 380, 450 mm
Groove digging and edging:
(1) Cold chisel
Total length: 300, 380, 450 mm
Asphalt cutting:
(1) Cutter
Width: 50, 75 mm
Total length: 400 mm
-1
-1
(2) Core (3) Core bit
bit shank