Bosch GLI18V-4000C Instrucciones De Funcionamiento Y Seguridad página 8

2610055548.qxp_GLI18V-4000C 3/26/20 2:05 PM Page 8
reduce the risk of starting the tool accidentally.
Inserting and Releasing
Battery Pack
listed in the battery/charger list. Using
other types of batteries may result in
personal injury or property damage.
To remove the battery pack, press the
battery pack release button 9 and slide
the battery pack 8 completely out of
floodlight housing (Fig. 2).
To insert battery, align battery and slide
battery pack into tool until it locks into
position (an audible click sound is an
indication that the battery is locked). Do
not force.
Button Cell Activation /
Replacement
CR2032 battery. Do not use any other
button/coin cells or other forms of
electrical power supply.
carried out properly. There is a risk of
explosion.
batteries away from children. This
product contains a lithium button/coin
cell battery. If a new or used lithium
button/coin cell battery is swallowed or
enters the body, it can cause severe
internal burns and can lead to death in
as little as 2 hours. If you think a battery
might have been swallowed or placed
inside any part of the body, seek
immediate medical attention.
cell lid. If the button cell lid does not
close securely, stop using the product,
remove the battery, and keep it away
from children.
Assembly
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety measures
Use only Bosch
BAT612 or batteries
Only use Button/coin
cell 3V lithium
Ensure that battery
replacement
Chemical Burn
Hazard. Keep
Always completely
secure the button
When discarding
batteries, insulate
Fig. 2
the '+' and '–' terminals with insulating
tape. When disposed of improperly,
lithium batteries may short, causing
them to become hot, burst or ignite.
expose to high heat. The batteries may
explode.
To enable the communication of this
cordless floodlight in the off state to a
mobile terminal/device, the cordless
is
floodlight is equipped with a button cell.
To activate the included button cell:
A. If battery pack 8 is inserted, remove
it.
B. Turn button
counterclockwise using flat head
screwdriver or a coin and remove the
button cell lid (Fig. 2).
C. Remove the protective film.
D. Insert the button cell 7. Make sure
that the positive pole is pointing
outside. Use only Lithium 3V CR2032
button cell battery.
E. Replace the button cell lid 6 and turn
it clockwise until the ▼ on the lid
aligns with
When replacing a button cell, follow
steps A–B and D–E.
Before the button cell runs out of
energy, the app displays a warning.
-8-
8 9
6
7
Never dispose of the
batteries in a fire or
cell lid
on the light housing.
6