Fine Adjustment - Waeco MagicSpeed HUD Instrucciones De Montaje

_MHUD-100.book Seite 23 Mittwoch, 11. Oktober 2006 9:17 09
MagicSpeed HUD
7.2 Rough adjustment
First you must make the rough adjustments on the display. Rough adjustment means
approximately adjusting the speed shown on the display to that of the speedometer.
For rough adjustment, you can choose the valued "P02", "P04", "P08" and "P16".
"P08" is set by default.
This is how to make the rough adjustment:
➤
Press the " " button once.
✓
The display switches to impulse value mode (fig. a, page 5).
➤
Drive the vehicle at a speed of around 40 km/h (according to the speedometer).
➤
Note the speed shown by the display.
➤
Stop the vehicle.
➤ Set the impulse value according to the table below:
Speed shown on the display
approx. 10 km/h
approx. 20 km/h
approx. 40 km/h
approx. 80 km/h
➤
Press the "▼" button to reduce the value, or
➤ ... press the "▲" button to increase the value.
➤
Press the " " to quit setup mode.
✓
The display save the current setting.
7.3

Fine adjustment

The purpose of fine adjustment is to exactly match the speed shown on the display
to that of the speedometer. Fine adjustment is possible within a range of 50 to 250.
"156" is set by default. Two increments correspond to approx. 1 km/h.
➤
Press the " " button twice.
✓ The display switches to fine adjustment mode (fig. b, page 6).
➤
Drive the car at an appropriate speed.
Caution!
Always pay attention to traffic while making the setting.
➤ Press the "▼" button if the value shown on the display is higher than that of the
speedometer, or ...
➤
... press the "▲" button if the value shown on the display is lower than that of the
speedometer.
➤
Press the " " to quit setup mode.
✓
The display save the current setting.
Using the display
Impulse value to set
P02
P04
P08
P16
23