To The Tv For Pip Operation - Sanyo DS32830H Manual Del Propietário

CONNECTING A SATELLITE SYSTEM, VCR, AND ANTENNA TO THE TV FOR PIP OPERATION
Cables are not supplied.
Connect an antenna signal to the TV 75Ω (ohm) terminal.
Connect Satellite S-Video Out to TV S-Video In jack. Using the S-Video In jack overrides the Video Input jack.
Connect the Satellite Audio Out (R/L) jacks to TV Audio Input (R/L) Jack (AV1) jacks.
Connect the VCR Audio/Video out jacks to the TV Audio/Video AV2 In jacks.
Connect RF cable from the Satellite Receiver "Out to TV" to the VCR "In from ant."
Press the POWER key to turn on the TV. Turn on external equipment.
TO USE PIP:
1. Press the PIP ON/OFF key.
2. Press the SELECT key to activate (highlight) the PIP window.
3. Press the INPUT key to select the input signal source for the PIP window (AV1 [Satellite], AV2 [VCR], or antenna).
4. Refer to page 16 to operate PIP, if needed.
– PIP feature will not function with just the satellite system, you must connect another signal source such
Notes:
as a cable system or antenna to the TV 75 ohms jack or AV jacks.
– This connection allows you to use your VCR to record a signal from the Satellite Receiver.
What you will need for connections:
Audio Cable – 1
S-Video Cable – 1
AV Cable – 1
RF Cable – 1
VCR Back
A/V JACKS
IN
RF
IN
FROM ANT.
CHANNEL
VIDEO L-AUDIO
CH3 CH4
OUT
OUT
OUT TO TV
VIDEO L-AUDIO
Antenna
PIP Satellite Hookup
Satellite Receiver
Back
CATV IN
CH3 A/V JACKS
CH4
OUT
OUT TO TV
VIDEO L- AUDIO
-R
-R
TV Back
VIDEO AUDIO INPUT
AV2
COMPONENT
S-VIDEO
Y
AUDIO
OUTPUT
(MONO)
P
L b L
R P R R
r
IN FROM
S-VIDEO
SAT.
-R
AV1
VIDEO
(MONO)
L L
UHF/VHF/CATV
75Ω
AUDIO
R
17