Hitachi NV 65AD3 Instrucciones De Manejo página 6

English
(3) Close the nail guide.
Grip the nail guide and knob. Then depress the knob
and turn the nail guide to the right. Nails are loaded by
adapting the above procedures.
NOTE:
The nail guide may not close properly or the nails may
not advance properly if the linked bands or nails do
not enter into the indicated position or the nails come
away from the guide surface or the wire linking the
nails is warped.
(4) Set the change lever
Turn the change lever in the direction of the arrow as
shown in Fig. 6 so that it corresponds to the linking
method for the nails being used.
Wire Collated
Nails
Change
Plastic Collated
Lever
Nails
NOTE:
If the position of the change lever is not set to the
linking position of the nails to be used, the nails will
not advance properly.
CAUTION:
To prevent unintentional operation, never touch the
trigger or place the top end of the push lever on a work
bench or floor. Also, never face the nail outlet toward
any part of a person.
HOW TO USE THE NAILER
CAUTIONS:
Never use the head or body of this device as a
hammer.
Take precautions to ensure the safety of persons in
the vicinity during operation.
1. Nailing procedures
(1) Method of intermittently driving nails (single shot)
The single-contact change lever is in the single shot
position (See Fig. 8)
This nailer includes a single shot structure to allow
striking of a single nail by pushing down the push
lever and pulling the trigger (see Fig. 7).
CAUTION:
[Method of intermittently driving nails (single shot)]
explained here is not [Sequential fire]. When Single-
contact Change Lever is at the Single shot position, if
the push lever is pushed up in a state where the trigger
is pulled, only one piece of nail in the nail outlet is
fired: Be careful!
In the event it is used by Sequential fire, use the
Sequential Fire Parts Set of OPTICAL ACCESSORY.
If you do not pull the trigger quickly and crisply while
in the single shot mode, the nailer will bounce and
5
Fig. 6
shoot several nails instead of just one. To avoid this,
be sure to pull the trigger quickly and crisply.
Trigger
Push Lever
Single Shot Position
Single-Contact
Change Lever
Push lever
When depressing the nail outlet, be sure to fully lift the
push lever (see Fig. 7) to release the safety lock. Thus,
nails cannot be driven without releasing the safety
lock even though the trigger is pulled.
(2) Method for continuous driving of nails (contact drive)
The single-contact change lever is in the contact driving
position (See Fig. 10).
Use the accessory hexagon bar wrench to turn the
single-contact change lever to the contact driving
position.
First pull back the trigger. Then press the nail outlet on
the place to drive nails. Driving of nails will start. (Fig.
9)
First, pull the Trigger
Next, depress the nail outlet
Fig. 7
Fig. 8
Fig. 9