Grounding Instructions - Sears 401.8505 serie Manual De Uso

WARNING
Improper use of the grounding plug can result
in a risk of electric shock.
GROUNDING
INSTRUCTIONS
This appliance must be
grounded. In the event of
an electrical short circuit,
grounding reduces the
risk of electric shock by
providing an escape wire for the electrical
current. This appliance is equipped with a cord
that includes a grounding wire and a grounding
plug. The plug must be plugged into an outlet
that is properly installed and grounded. See
Installation Instructions.
This appliance must be connected to a
grounded, metallic, permanent wiring system or
an equipment grounding conductor should be
run with the circuit conductors and connected to
the equipment grounding terminal or lead on
the appliance.
grounding instructions are not completely
understood, or if doubt exists as to whether the
oven is properly grounded.
Do not use an extension cord. If the product power
install a three-slot receptacle. This oven should
be plugged into a separate 60 Hertz circuit with
table. When the oven is on a circuit with other
equipment, an increase in cooking times may be
required and fuses can be blown.
Microwave operates on standard household
current, 110- 120V.
8505_XAA_03805A-EN+MES.indb 5
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
FEDERAL
COMMUNICATIONS
COMMISSION RADIO
FREQUENCY INTERFERENCE
STATEMENT (U.S.A. ONLY)
This equipment generates and uses ISM
frequency energy and if not installed and
used properly, that is in strict accordance with
the manufacturer's instructions, may cause
interference to radio and television reception. It
has been type tested and found to comply with
limits for ISM Equipment pursuant to part 18
of FCC Rules, which are designed to provide
reasonable protection against such interference
in a residential installation.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following:
Reorient the receiving antenna of the radio
or television.
Relocate the microwave oven with respect
to the receiver.
Move the microwave oven away from the
receiver.
Plug the microwave oven into a different
outlet so that the microwave oven and the
receiver are on different branch circuits.
The manufacturer is not responsible for any
radio or television interference caused by
oven. It is the responsibility of the user to
correct such interference.
5
2010-07-08 6:45:47