Machine Components; Machine Installation - Metabo DS 125 W Instrucciones De Servicio

Machine Components

Comment: Several constructive details distinguish these
double grinding machines. The handling, described in
the following, is in principle the same with all machines.
5
4
1
1 Switch ON/OFF
2 Tool rest, left
3 Grinding wheel, left
4 Power cable with plug
5 Indicator for direction of rotation (sticker)
6 Spark protection assembly
7 Grinding wheel, right
8 Tool rest, right

Machine Installation

The grinding machine should be firmly mounted in a
suitable location. For mounting on a firm and flat base 4
holes are provided in the machine's base (see arrows in
fig. 2). The height should be chosen so that the tool rest
is at about elbow height. Ensure a power outlet is
available at a distance of approx. 100 - 150 cm.
Metabo can supply floor or wall mounted supports (see
fig. 2) fulfilling the requirements for stability and correct
working height.
9
2
9 Wall bracket
10 Pedestal support base
Installation of Spark Protection Assembly
For reasons of packing the spark protection assembly is
not factory installed and needs to be user installed before
operation of the machine. Fig. 3 shows the components
of the spark protection assembly and how they are
installed to the grinding wheel cover on the right hand
side.
Installation to the left hand side wheel cover is similar.
5 6
6
7
8
2 1
3
10
stock-no. 090 000 1150
stock-no. 090 000 1134
3
F
3
A adjusting guard plate
B hexagon head bolt M 4 x 55
C lock washer
D hexagon nut M 4
E spark glass guard
F slotted screws
G disk
H hexagon head screw M 5 x 20
Setting of Tool Rest and Spark Arrester
Bracket
The tool rest and spark protection assembly's spark
arrester bracket have to be set from time to time to
compensate for grinding wheel wear. The gap between
tool rest and wheel should not be more than 2 mm and
not more than 2 mm between wheel and spark arrester
bracket.
4
1 Grinding wheel
2 Tool rest
3 Spark arrester bracket
8
D
C
F
A
G
H
D
C
A
B
3
1
2
E
E