Skil 2000 Manual De Instrucciones página 11

Do not repeatedly recharge the battery after only a few
minutes of operation; this may result in a reduction of
operating time and battery efficiency.
The nickel-cadmium battery must be kept separate from the
natural environment and should not be disposed of as
normal domestic waste.
§
Prior to disposal protect battery terminals with heavy
tape to prevent short-circuit.
If you anticipate long periods of non-use for the tool, it is
best to unplug the charger from its power source.
Inserting the accessory
§
Before any work on the machine itself, remove the
battery.
Screwdriving
Insert the bit G into the tool holder A or when using screw-
driver bits G, additionally use the universal bit holder H.
§
Do not use bits with a damaged shank.
Starting operation
ON/OFF SWITCH (see figure 3)
To start the machine, press the On/Off switch C and keep it
depressed and to switch off the machine, release the
On/Off switch C.
Attention: If the rotational direction switch B to the centre
position is not possible press the On/Off switch C.
REVERSING THE ROTATIONAL DIRECTION
§
Operate the rotational direction switch B only at a
standstill.
The rotational direction switch B is used to reverse the
rotational direction of the machine. However, this is not
possible with the On/Off switch C actuated.
Right Rotation: Press the rotational direction switch
through (normal operation: drilling, screwdriving, etc.).
Left Rotation: Press the rotational direction switch through
(for loosening and unscrewing screws and nuts).
When not properly set in left/right position, switch C
can not be activated.
Application device
Use the appropriate bits.
! Do not use damaged bits.
When turning in a screw at/near the cross cut end or an
edge of wood one should pre-drill a hole in order to avoid
cracking of the wood
For an optimal use of the tool a steady pressure on the
screw is required, especially while removing
When screwdriving in hard wood one should pre-drill a hole
Maintenance
§
Unplug charger from power source before cleaning.
For safe and proper working, always keep the machine and
the ventilation slots clean.
Keep tool and charger clean.
- The charger may be cleaned most effectively with
compressed air (wear safety goggles).
- Clean charging contacts in charger with alcohol or contact
cleaner.
If the machine should fail despite the rigorous
manufacturing and testing procedures, repair should be
carried out by an authorized customer services center for
SKIL Power Tools
Guarantee
We guarantee SKIL appliances in accordance with
Statutory/country-specific regulations (proof of purchase by
invoice or delivery note).
Damage attributable to normal wear and tear, overload or
improper handling will be excluded from the guarantee.
In case of complaint please send the machine,
undismantled, to your dealer or the SKIL Service Center
for Electric Power Tools.
Warning!
Freight and insurance costs are charged to the client, even
for warranty claims.
Environmental protection
Recycle raw materials instead of disposing as waste.
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
The plastic components are labeled for categorized
recycling.
The nickel-cadmium battery must be kept separate from the
natural environment and should not be disposed of as
normal domestic. Do not use tool or charger when
damaged; take it to one of the officially registered SKIL
Service Stations for a safety check.
Subject to change without notice
11