Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GAS COOKTOP INSTALLATION INSTRUCTIONS
2. Turn on Electrical Power and Open Main Shutoff
Gas Valve
3. Check the Igniters
Operation of electric igniters should be checked after
cooktop and supply line connectors have been carefully
checked for leaks and the cooktop has been connected
to electric power.
To operate the surface burner:
A. Push in and turn a surface burner knob to the LITE
position. You will hear a small ticking noise; this is the
sound of the electric ignitor which lights the burner.
B. After the burner lights, turn to the desired flame size.
The controls do not have to be set at a particular
mark. Use the marks as a guide and adjust the flame
as needed.
4. Adjust the "low" setting for regular surface
burner valves (Figure 13)
a. Push in and turn control to LITE until burner ignites.
b. Quickly turn knob to LOWEST POSITION.
c. If burner goes out, reset control to OFF.
d. Remove the surface burner control knob.
e. Insert a thin-bladed screwdriver into the hollow valve
stem and engage the slotted screw inside. Flame
size can be increased or decreased with the turn of
the screw. Turn counterclockwise to increase flame
size. Turn clockwise to decrease flame size. Adjust
flame until you can quickly turn knob from LITE to
LOWEST POSITION without extinguishing the flame.
Flame should be as small as possible without going
out. Note: Air mixture adjustment is not required on
surface burners.
5. Adjust the "LOW" Setting of the Bridge Burner
Surface Valve (Figure 13) (some models):
Note: On the dual valve the low setting of each portion
(rear portion of bridge burner and the center portion of
bridge burner) should be adjusted individually.
a. Push in and turn control to LITE until the rear portion
of the bridge burner ignites only.
b. Quickly turn knob to LOWEST POSITION.
c. If burner goes out, reset control to OFF.
d. Remove the surface burner control knob.
e. The rear portion of the bridge burner flame size can
be increased or decreased with the turn of the screw
A. Use screw B to adjust the flame size of the center
portion of the bridge burner. Turn counterclockwise
the screw to increase flame size. Turn clockwise the
screw to decrease flame size. Adjust flame until you
can quickly turn knob from LITE to LOWEST POSITION
without extinguishing the flame. Flame should be as
small as possible without going out. Note: Air mixture
adjustment is not required on surface burners.
(For 30" & 36" Models)
Counter clockwise
Hollow
Regular
Burner
Valve
When All Hookups are Complete
Make sure all controls are left in the OFF position.
Make sure the flow of combustion and ventilation air to
the cooktop is unobstructed.
Model and Serial Number Location
The serial plate is located on the underside of the
cooktop.
When ordering parts for or making inquires about your
range, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
of your cooktop.
Your serial plate also tells you the rating of the burners,
the type of fuel and the pressure the cooktop was
adjusted for when it left the factory.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide.
It may save you time and expense. The list includes
common occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to your Use and Care Guide for Sears service
phone numbers, or call 1-800-4-MY-HOME
9
A
Valve
Stem
B
Figure 13
Clockwise
Bridge
Burner
Valve
®
.
Publicidad
Tabla de contenido
