Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of
an electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for
the electric current. This appliance is equipped with
a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded.Consult a qualified
electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to
whether the appliance is properly grounded.
WARNING
Improper use of
the grounding plug
can result in a risk of
electric shock.
Do not use an
extension cord. If the
power supply cord
is too short, have a
qualified electrician
or serviceman install
an outlet near the
appliance.
ELECTRICAL REQUIREMENTS
Product rating is 120 volts AC, 60 Hertz, 14.5 amps
and 1.70 kilowatts. This product must be connected to
a supply circuit of the proper voltage and frequency.
Wire size must conform to the requirements of the
National Electrical Code or the prevailing local code
for this kilowatt rating. The power supply cord and
plug should be brought to a separate 15 to 20 ampere
branch circuit single grounded outlet. The outlet box
should be located in the cabinet above the oven. The
outlet box and supply circuit should be installed by
a qualified electrician and conform to the National
Electrical Code or the prevailing local code.
Installation Instructions
Permanent and Correct
Installation
3-Prong plug
Grounding pin
3-Prong receptacle
Grounded receptacle box
CUTOUT DIMENSIONS
Models
Height
Width
Depth (min.)*
* Min. depth with receptacle outside cabinet 19
Min. depth with receptacle inside cabinet 22"
"
1
1 4
27
"
30
1
beyond Trim Frame
(on all sides)
CAUTION
This trim kit uses air flow from the top, bottom and
sides of the trim frame. Blocking the air flow can
cause the microwave to function improperly and
may cause damage to the microwave.
Allow a 1
clearance beyond the edge of the Trim
"
Frame to provide proper air flow.
On 27
models, allow 1
"
and 1
at the bottom for overlap of the Trim Frame
"
over the edges of the cutout.
On 30
models, allow 1
"
and 1
at the bottom for overlap of the Trim Frame
"
over the edges of the cutout.
For ADA Compliance, the microwave must be
installed no higher than 36
2
27
"
16
16
3 4
"
25
25
1 2
"
19
or 22
19
1 2
"
"
1 2
"
overlap
"
"
Models:
overlap
9 16
"
Models: 2
overlap
1 8
Height
Width
"
"
1
overlap
Clearance
at the top,
on the sides
1 4
"
9 16
"
at the top, 2
on the sides
1 4
"
1 8
"
1 4
".
30
"
3 4
"
1 2
"
or 22
"
1 2
"
Depth
"
3
min.
Publicidad
Tabla de contenido
