Safety Information; Layout And Items Supplied - EINHELL 45.021.18 Manual De Instrucciones Original

Danger!
When using the guide rail system, a few safety
precautions must be observed to avoid injuries
and damage. Please read the complete operating
manual with due care. Keep these operating
instructions in a safe place so that the information
is available at all times. If you give the guide rail
system to any other persons, give them these
operating instructions as well. We can accept no
liability for damage or accidents which arise due
to non-compliance with these instructions.

1. Safety information

Read all the instructions for the guide rail
system and all the instructions and safety
information for the plunge/hand-held circular
saw!
Failure to comply with the instructions for the
guide rail system and the instructions and safety
information for the plunge/hand-held circular saw
may result in an electric shock, fi re and/or serious
injury.
Keep all the instructions and safety
information in a safe place for future use.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Guide rail (2x)
2. Screw clamp (2x)
3. Connecting piece
4. Hexagon key
2.2 Items supplied
•
Open the packaging and take out the guide
rail system with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
present).
•
Check to see if all the items are supplied.
•
Inspect the guide rail system and the
accessories for transport damage.
•
If possible, keep the packaging until the end
of the guarantee period.
Danger!
The guide rail and packaging material are
not toys! Do not let children play with plastic
bags, foils or small parts! There is a risk of
choking and suff ocating!
Anl_Fuehrungsschiene_SPK9.indb 11 Anl_Fuehrungsschiene_SPK9.indb 11
GB
3. Use
The guide rail system enables exact and straight
cuts to be made. It can be used for 0°/90° cuts
and for 45° cuts.
4. Assembly (Fig. 2)
To assemble the 2 guide rails, proceed as follows.
•
Push the connecting pieces (3) half-way into
the bottom side of the guide rail (1a). Make
sure that the heads of the hex screws (a+b)
are visible.
•
Tighten the 4 socket head screws (a) using
the hexagon key (4).
•
Now slide the other guide rail (1b) onto the
projecting half of the connecting pieces (3)
until both rails are in contact with each other.
•
Now tighten the 4 socket head screws (b)
using the hexagon key (4).
•
Check whether the two rails are now securely
joined together by pulling on them.
•
To dismantle, proceed in reverse order.
The two guide rails can also be used separately
on their own.
5. Fastening (Fig. 3)
Fasten the guide rail system (1) to the workpiece
with the screw clamps (2). This is to prevent the
rail from slipping. Proceed as follows:
•
Place the rail on the workpiece.
•
Fit the screw clamps (2) into the guide (c) on
the guide rail system (1).
•
Tighten the screw clamps.
If the rail is longer than the workpiece, you
can also slide the screw clamp as far as the
workpiece underneath the rail and then fasten it.
For an optimum hold, fasten the guide rail system
on both sides.
- 11 -
15.05.2018 15:16:38 15.05.2018 15:16:38