Disposal And Recycling - EINHELL 45.021.18 Manual De Instrucciones Original

6. Working with the guide rail
system (Fig. 4-6)
Danger!
Before working with the guide rail system,
please also read the operating instructions
and safety information issued for the plunge/
hand-held circular saw.
Important!
When the fi rst cut is made, a piece of the rubber
lip at the edge of the guide rail will be cut off (see
Fig. 6). This ensures that the rubber lip rests
exactly against the saw blade. Therefore, use a
waste piece for this fi rst cut.
1. Mark up your workpiece.
2. Position the guide rail (1) so that the edge of
the guide rail (1) rests against the marker line
on the workpiece.
Important!
The correct side of the rail must be placed against
the marker line according to the type of cut
(0°/90° or 45°) to be performed:
0° and 90° cuts
The broad side must be placed against the line,
see Fig. 4
45° cuts
The narrow side must be placed against the line,
see Fig. 5
3. Fasten the guide rail system as described in
section 5 "Fastening".
4. Adjust the saw as required and place it on the
guide rail system (1).
5. Make sure that the recess (d) in the saw
table fi ts on the elevation (e) in the guide rail
system.
6. Switch on your circular saw and move it
evenly with little force along the guide rail
system.
Important!
Do not let your saw stand stationary on the
projecting guide rail system. This could cause
damage to the rail.
Important!
When you use the guide rail system, remember
that the device is now higher by the amount of the
guide rail system (6 mm) and that the scale for
the sawing depth on the device can no longer be
Anl_Fuehrungsschiene_SPK9.indb 12 Anl_Fuehrungsschiene_SPK9.indb 12
GB
used on a 1:1 basis.
For the hand-held circular saws in this case, set
the required cutting depth 6 mm higher.
Example: Required cutting depth 30 mm -->
Setting if the guide rail system is used 36 mm
For the TE-PS 165 plunge saw, use mark "B"
for the depth setting. To do so, please read the
instructions for the plunge saw.
Important!
When you use the guide rail system, the sawing
line mark for 45° cuts in the saw foot on the
device no longer corresponds with the cut. This is
now slightly off set, because the device is higher
by the amount of the guide rail system.
7. Cleaning
We recommend that you clean the guide rail and
its accessories immediately after use. Clean the
guide rail with a damp cloth and some soft soap.
Do not use cleaning agents or solvents; these
may be aggressive to the plastic.

8. Disposal and recycling

The guide rail is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused or
recycled. Defective components of the guide rail
must be disposed of as special waste. Ask your
dealer or your local council!
The reprinting or reproduction by any other
means, in whole or in part, of documentation and
papers accompanying products is permitted only
with the express consent of the iSC GmbH.
Subject to technical changes
- 12 -
15.05.2018 15:16:38 15.05.2018 15:16:38